Search found 4 matches

Go to advanced search

by Mordred
Thu May 19, 2016 2:08 pm
Forum: Other technical advice
Topic: Engraving Speed
Replies: 7
Views: 1038

Re: Engraving Speed

Striker wrote:From what you are saying, my calculations tells me that it would take up to 40 seconds to engrave an area of 1 x 1 inch at .1mm step over and at about 280 ipm. I am I right to say so?
yeah, that’s right.
by Mordred
Thu May 19, 2016 2:02 pm
Forum: Other technical advice
Topic: Engraving Speed
Replies: 7
Views: 1038

Re: Engraving Speed

Thanks for that, but what could be the required step over to the next pass? Does it depend on material and focus only? What is the typical value? You are absolutely right. It depends mostly on the material. The general thumb of rule is that a .1mm is the best target. In my laser, the spot size rang...
by Mordred
Thu May 19, 2016 1:52 pm
Forum: Other technical advice
Topic: Engraving Speed
Replies: 7
Views: 1038

Re: Engraving Speed

This goes for those who have built or know about laser engravers. I am currently building one for myself. I would love to know the maximum engraving speed that I need to plan for when I will be engraving. I need something that moves pretty faster. There is plenty of speed to choose from. However, i...
by Mordred
Thu May 19, 2016 1:46 pm
Forum: General Discussion
Topic: Help set up Port to trigger rely on plasma torch
Replies: 1
Views: 911

Re: Help set up Port to trigger rely on plasma torch

I am not an expert in this but let me try. Use your BOB to set up the Output No with the pin numbers. Go to spindle setup for CW and select the output # that you used for mach 3.
Can’t help beyond that. Am sorry.
Mordred

Go to advanced search



  •  The team

  •  Search
  • Advanced search


  •  Top Posters

  •  Newest members

  •  Who is online?




 

 

cron