4Axis Chinese CNC Kit

[Talai]

I have a 4axis Chinese CNC kit with TB6560 driver board and a power supply which unfortunately has stopped working. I also realized that the y axis motor is no longer moving. is there any hope for getting a replacement for the motor or should I use a CNC USB controller? Will the controller work with nema23 motors that the kit has?

[FireCNC]

Yes it will definitely work. But wait a minute, which USB controller are you intending to use?

[Talai]

I was thinking of using MK1 axis or MK 4 axis.

[FireCNC]

Forget about mk1 as it is obsolete. It is no longer supported.mk ¾ is good because it runs smoother than mk4 and has got a lot of new features that are supported mainly on mk3 series.

[Talai]

Thanks so much for the help. How about if I buy MotorDrive 2.5A x 4 no. ?

[FireCNC]

Thanks so much for the help. How about if I also buy MotorDrive 2.5A x 4 no. ?

That will absolutely work very well.